fret slot depth
Fret Slotting Saw
Fret Slotting Saw
Fret Slotting Saw fret slot depth I use an Irwin dovetail pull saw with a bit of wood super glued to the saw to stop the cut at the correct depth The saw follows the radius of fret slot depth Fretwire has a toothed piece called the tang which will stick into a slot in the fretboard The tang is typically in width, so ideally you
fret slot depth It currently has the original vintage fretwire with tang depth around 060 I would like to install jumbo EVO 57110 fretwire but it has tang
fret slot width What is the nominal fret slot width? If you target is , you will not get that with a cutter If your target is , you might Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough! Not sure if your fret slots